industrial vacuum dust collector enterprise cooling the important role: Because the temperature of the flue gas is as high as 550° at some time, industrial vacuum dust collector enterprise is unable to get used to this environment, so three cooling methods should be selected for the dust collector. In the industrial vacuum dust collector enterprise set up a gas cooler, it can assist in lowering the air temperature, air and water, some cool wind and water cooling. These cool breezes and cold water are able to assist in cooling the smoke and then decrease the warmth of the bag dust collector. Cloth bag dust collector is a dry dust filter device. It is suitable for capturing fine, dry, non-fibrous dust. industrial vacuum dust collector enterprise in high temperature, can install a cool air valve, the cool air valve is mainly to avoid some high temperature flue gas into the dust collector, it is to play the function of conditioning, its one end is connected with high temperature pipe, and the other end is connected with the atmosphere. Therefore, before the use of industrial vacuum dust collector enterprise, it is better to install these equipment. In this way, the function of the dust collector can be carried forward, and the dust collector will not be damaged due to unacceptable high temperature. Some low-temperature flue gas can be properly mixed. If the temperature of the gas in the dust collector is not the same, the best way is to mix a part of the low-temperature gas into the high-temperature flue gas first, so that the gas can be mixed and the temperature in the dust collector is not so high.

There are many kinds of industrial vacuum dust collector enterprise, so its selection accounting is very important. Improper selection, such as equipment is too large, will not form the flow cost; Equipment selection will affect production, difficult to satisfy the environmental requirements. Meanwhile, the value of the resistance of industrial vacuum dust collector enterprise is a problem that can not be ignored, which is directly related to the type selection and numerical determination of dust collector. The resistance of an industrial vacuum dust collector enterprise consists of the following three parts:

First, the resistance of the dust removal equipment body structure refers to the resistance of gas from the dust collector to the dust collector inlet;

Two, the resistance of the dust bag, refers to the resistance of the filter material to filter dust, about 50~150Pa;

Three, the resistance of the dust layer on the surface of the dust bag, the resistance of the dust layer is about 1~10 times that of the clean press cloth.

industrial vacuum dust collector enterprise adopts off-line pulse cleaning. It is a kind of unit combination dust collector with large air volume, good dust removal effect, good dust removal rate, convenient operation, maintenance and small footprint. The body of pulse dust collector adopts special treatment and has good service life. Foundry is more suitable for the use of bag dust collector, bag dust collector body structure is mainly through the upper part of the box into the middle box through the air inlet pipe, later by the lower box (ash bucket), dust cleaning system and exhaust mechanism and other parts. Pulse dust collector dust removal rate is good, can capture particle size of more than 0.3 micron fine dust, dust removal rate is good, and the structure is relatively simple, stable operation, less initial investment, convenient maintenance. In addition to the correct selection of bag material, the dust cleaning system plays a decisive role in the performance of bag dust collector. Therefore, the cleaning method is one of the characteristics to distinguish the bag dust collector, but also an important link in the operation of the bag dust collector.

industrial vacuum dust collector enterprise https://www.kaisenfilter.com/KSG-1-0-B-High-Vacuum-Fume-Extractor.html